Heating Oil Service Plans

Peace of mind in case we need to repair your heating system
Did you know that heating systems break down most often when the weather is the most severe? That’s when your comfort systems are under the most stress. Plus, if your systems are older or you skip regular maintenance for them, your chances of having a breakdown increase dramatically. To prevent these problems, we developed three heating oil service plans: Elite Protection, Premier Protection & Stay Warm Comfort Plan.
Our plans include the most extensive written guarantees ever offered by a home comfort provider in our area.
- You will not be charged overtime for emergency repairs if you’re covered by the Elite or Premier Protection Plan.
- Annual tune-ups are included in the plans. Tune-ups prevent breakdowns, extend equipment life and cut energy costs by ensuring your system runs at peak efficiency. In fact, our expert tune-ups can save you as much as 10% on your annual fuel bills.
Click each plan info below to see full details.
Premier | Elite | Oil Stay Warm Comfort Plan
See our Terms & Conditions
Premier Protection Plan includes:
- FREE overtime charges
- FREE annual boiler or furnace tune-up
- FREE parts and labor on everything in our Elite Protection plan plus many other significant additions
- priority service
Your boiler or furnace will be tuned up annually to ensure that your heating system operates at maximum efficiency. We will:
- test and adjust oil burner for maximum efficiency, using combustion testing equipment
- inspect combustion chamber
- oil all motors on burner, fans and circulators
- clean and check electrodes and nozzle assembly
- install air filters, supplying oil filter cartridge and burner nozzle, if necessary
- check all safety and operating controls
- check oil tank and oil lines
- vacuum furnace and flue pipe, including chimney base (where accessible)
Our Premier Protection Plan includes everything in our Elite Protection Plan plus the significant addition of the following major parts and services to give you maximum protection and peace of mind.
- air vents
- automatic water feeder
- baffle
- bearing assembly
- blower motor (non-ECM, up to 3/4 hp)
- boiler valves
- circuit breaker
- circulator complete
- circulator impeller
- circulators and zone valves (unlimited)
- combustion chamber
- expansion tank
- Extrol tank
- feed valve
- flow valve
- gauge glass set
- humidifier fan
- humidifier motor
- humidifier pad
- low water cutoff
- mixing valve element
- PressureTrol
- purging of complete system (if necessary)
- Pyrostat
- relief valve
- solenoid valve
- Space-Gard air cleaner element
- temperature gauge
- thermostat (clock or programmable digital)
- zone valve complete
- zone valve stem
It is our goal to reward our loyal customers. You earn $75 in Loyalty Credits each year you purchase a service plan, up to a lifetime maximum of $600 while you are a customer. You can use these credits toward the purchase of a variety of heating and cooling equipment. (The figures below show how much can be used for any one item.) Credits are not transferable and have no cash value. They have value only as a credit toward the following equipment purchased from Wilson by its customers.
boiler
$600
burner
$100
gas or electric water heater
$150
central a/c system
$250
domestic hot water coil
$150
programmable digital thermostat
$50
oil-fired water heater/indirect tank
$300
germicidal ultraviolet light
$50
ecomatic control
$300
HEPA central air purifier
$200
furnace
$250
combustion chamber
$150
oil tank
$350
heating & a/c system
$500
Elite Protection Plan includes:
- FREE overtime charges
- FREE annual boiler or furnace tune-up
- FREE parts and labor on some heating repairs (see complete list)
- priority service
Your boiler or furnace will be tuned up annually to ensure that your heating system operates at maximum efficiency. We will:
- test and adjust oil burner for maximum efficiency, using combustion testing equipment
- inspect combustion chamber
- oil all motors on burner, fans and circulators
- clean and check electrodes and nozzle assembly
- install air filters, supplying oil filter cartridge and burner nozzle, if necessary
- check all safety and operating controls
- check oil tank and oil lines
- vacuum furnace and flue pipe, including chimney base (where accessible)
This plan covers many things that typically can go wrong with your system and includes an annual tune-up. Also, Wilson will repair or replace, during the life of this service plan, with no charge for parts and labor, any of the following items that may become defective due to normal use or wear and tear.
Controls
- aquastat
- cad cell control
- circulator control
- combination control
- draft regulator
- emergency switch
- fuses
- high limit control
- low limit control
- primary control
- reverse aquastat
- stack control
- thermostat (manual or nonprogrammable digital)
- triple aquastat
Furnace Systems
- air cones
- air diffuser
- air filter, standard (one set)
- air regulator
- air stat
- blower bearings
- blower belt
- blower complete
- blower motor (non-ECM, up to 1/3 hp)
- blower pulley
- blower shaft
- blower wheel
- fan control
- limit control
Burner Replacement Parts
- burner blast tube
- burner coupling
- burner fan
- burner flange gasket
- burner motor
- buss bar transformer leads
- cad cell assembly
- cad cell eye
- delayed oil valve
- delayed oil valve coil
- electrode assembly
- electrodes
- end cone
- ignition transformer
- ignition wiring
- low voltage transformer
- low voltage wiring (exposed)
- nozzle
- nozzle adapter
- nozzle line
Boiler Systems Main Zone
- circulator coupling
- circulator motor (excludes cartridge circulator type motors)
- circulator motor mounts
- circulator switch
- circulator wicking
- zone valve motor
- zone valve relay
Services
- adjusting boiler pressure
- adjusting water level
- venting baseboard radiators
Fuel Supply Parts
- Firomatic valve
- flare fittings
- fuel filter cartridge
- fuel filter complete
- fuel pump
- fuel pump bleeder
- fuel pump seal
- fuel pump strainer
- oil line (exposed)
- oil line fittings
It is our goal to reward our loyal customers. You earn $75 in Loyalty Credits each year you purchase a service plan, up to a lifetime maximum of $600 while you are a customer. You can use these credits toward the purchase of a variety of heating and cooling equipment. (The figures below show how much can be used for any one item.) Credits are not transferable and have no cash value. They have value only as a credit toward the following equipment purchased from Wilson by its customers.
boiler
$600
burner
$100
gas or electric water heater
$150
central a/c system
$250
domestic hot water coil
$150
programmable digital thermostat
$50
oil-fired water heater/indirect tank
$300
germicidal ultraviolet light
$50
ecomatic control
$300
HEPA central air purifier
$200
furnace
$250
combustion chamber
$150
oil tank
$350
heating & a/c system
$500
Oil Stay Warm Comfort Plan includes:
- reduced diagnostic fee of $49
- 15% discount on all parts and labor (excludes replacement or installations of heating system)
- priority service
- annual tune-up included
- $50 in Loyalty Credits for year the plan is renewed
Your boiler or furnace will be tuned up annually to ensure that your heating system operates at maximum efficiency. We will:
- test and adjust oil burner for maximum efficiency, using combustion testing equipment
- inspect combustion chamber
- oil all motors on burner, fans and circulators
- clean and check electrodes and nozzle assembly
- install air filters, supplying oil filter cartridge and burner nozzle, if necessary
- check all safety and operating controls
- check oil tank and oil lines
- vacuum furnace and flue pipe, including chimney base (where accessible)
15% discount on all parts and labor (excludes replacement or installations of heating system).
It is our goal to reward our loyal customers. You earn $50 in Loyalty Credits each year you purchase a service plan, up to a lifetime maximum of $600 while you are a customer. You can use these credits toward the purchase of a variety of heating and cooling equipment. (The figures below show how much can be used for any one item.) Credits are not transferable and have no cash value. They have value only as a credit toward the following equipment purchased from Wilson by its customers.
boiler
$600
burner
$100
gas or electric water heater
$150
central a/c system
$250
domestic hot water coil
$150
programmable digital thermostat
$50
oil-fired water heater/indirect tank
$300
germicidal ultraviolet light
$50
ecomatic control
$300
HEPA central air purifier
$200
furnace
$250
combustion chamber
$150
oil tank
$350
heating & a/c system
$500